Finished arcade controller.
Complete Original XBox 360 housing. Painted Red.
Cheap Xbox 360 Controller.
Controller Housing removed.
Rumble motors cut.
Plastic broken off to reduce bulk.
One thumb stick extended off the board with header pin connectors.
All controls extended off the board to header pin connectors.
Wiring added to connect Xbox front USB ports to a usb hub.
Controller, hub and front usb ports wired up.
Marked and pilot holes drilled.
Back of the housing trimmed flat with a rotary tool
LED units installed to replace rumble motors.
Controls installed into housing top
Front USB Ports, Hub and controller board installed.
Connector and wiring in testing
Bottom of controls, wiring partially done.
Testing thumb sticks.
All wiring complete. Ready to close, secure and play.
Tact switch hot glued where previous on/off switch was installed. LED added to make ring of light glow.
Finished arcade controller