120v SETUP: 70amp 120v circuit breaker panel box. About $13 at home depot. Two breakers- 20amp for the AC and 15amp for the Outlets and Battery Charger.
1.5" insulation panels finished off with spray foam in a can.
All the lighting wires are set in position.
Starting on Paneling. These are 1/8" Luann panels from Home Depot. You have to install nailer strip wherever there is an edge or else it will ripple. I used 2.5" 25ga metal stud track to support the edges. This seem will be hidden by a closet/cabinet.
Once the panels are cut and fit we remove them and glue on the carpet.
Here is the 120v breaker panel and an outlet by the rear driver's side. There is a 30amp whip that fits inside the panel with a round cap for shore power.
I used 3/4" self tapping screws 12" on center.
NOTE- I used a round corner bead strip for the roof nailer. The self tapping screws hold fine. It's really there to keep the rippling down to a minimum.