A box in a box, money well spent!
Let's begin to unwrap...just like Christmas!
Notice no instructions.
String already ran to pull servo wire.
Eye candy for sure.
Pull - pull cable already ran.
Cobra 2820/14, CC Ice 75, Hi-Tec HS-5065MG, Hyperion Spinner, 11 x 7E Prop
Assemble wheel on axle. Be sure to file a flat!
Carefully insert in wheel pant and tighten lock nut.
Hobbico hot knife.
Mark cut outs with a marker.
Carefully cut out.
Start small, then work out.
Time to tighten covering.
She is too young to have wrinkles!
Wood can shrink in shipping.
My home made stand.
Works for me.
Used the shorter of the 3mm screws provided.
Tricky to find tail slot in side.
Bottom of rudder.
Be careful to cut in the right spot!
Tail wheel wire.
Glued in with 30 minute epoxy.
Turnigy servo tool.
3DHS 47" Osiris
Had to modify holes.
Rudder servo mounted
May be too long, we'll see?
Slide in left side of elevator.
Use painter's masking tape to hold centered. Apply thin CA to hinges. 2 drops each.
Use thick CA to glue connecting arm.
Apply thin CA to right side elevator.
Use masking tape to all four cowl mounting points. Mark where to drill the holes
Slide cowl into correct positino and drill holes.
Tail feathers attached and cowl on.