Lower longeron patch.
Bent lower longeron.
Corrosion on the lower boot cowl former.
Tube over a tube repair on the front lower longeron.
Bent door post tube.
Bowed upper engine mount support.
Rear seat tube corroded and tab broken off.
Corrosion and external patch at "D" window.
Previous repairs on the bird cage.
Splices in the RH landing gear tube.
Splices in the left landing gear tube.
Pitting on the front left gear attach fitting.
Fuselage ready to blast.
Usual tail post and lower longeron corrosion.
Soft spots in lower longeron.
Corrosion in diagonal.
Rt. D window corrosion.
Lower door post cracked at liner tube.
Square seat tube corroded.
Other end of seat tube.
Pin hole at the cluster behind the sliding window.
Hole in the V tube at the front wing attach.
Boot cowl former corrosion.
Pitting at wing/strut attach but the tube is solid.
Pitting at center stringer attach on bottom fuselage tube but is not soft.
Hole in bottom longeron at step clamp.
Lower longerons at tail post.
Lower longeron pitting.
Other side of corroded diagonal.
Top longeron bent on bottom where someone tried to straighten the tail.
Top longeron bent on top where someone tried to straighten the tail.
Rear liner tube support is very loose and needs support tube replaced.
Left bottom longeron and diagonals replaced.
Right bottom longeron fitted.
Tube was in a slight bind.
Fitting the door opening to the door.
A couple of tubes popped out when cut loose.
Front door tube.
Holes in the front wing attach tube.
Front wing attach tube cut, fit and tack welded in place along with front door frame and front gear fitting tube.
Front structure repaired and tack welded in place.
Structure tach welded and door/window fit.
Structure welded out at front gear fitting and door post.
Ring front wing attach welded out.
Longerons and tail post tubes welded out.
Tail ready for tailspring bracket.
Rear stabilizer attach tube cut out due to worn inside diameter.
Preliminary fit of forward tail spring fitting.
Longeron splice, finish weld when on the rotisserie.
Corrosion under rear door post trim.
New "D" window welded in.
Rear seat back tube repaired.
Elevator cable pulley bracket modification.
Rear elevator pulley bracket modification.
Forward elevator cable modification.
Pulley bracket welded onto torque Tube.
Seat belt to floor modification.
Tailpost and associated repairs.
Tail brace wire attach bracket welded in.
Rear liner tube fitting replaced and nut for grease zerk welded in.
Upper deck fixture installed.
Super Cub elevator control system front pulley bracket.
Fairlead for Super Cub elevator control system.
Seat belt to floor attachment modification.
New rear seat tube.
Super Cub type rear baggage floor channels.
Repaired seat back tube.
New "D" window and door post tube and channel.
Super Cub type rear baggage side panel attach tabs.
Rear diagonal tube repair.
New liner tube carry-thru tube w/grease zerk attach.
Lower longerons, clusters, tail brace wire attach and tail spring attach brackets.
Replaced previous lower longeron patch with tube in a tube splice.
Super Cub elevator pulley attach bracket.
Super Cub type baggage compartment side panel attach tabs.
Boot cowl formers.
Upper deck superstructure.
Lower boot cowl former and stringer.
Patch over pitted carry-thru tube.
Patch and stringer attach bracket.