Need to fix the button on the bottom left, mixed up the connection sides!
Look at those sexy jumper wires! My breadboards look clean, how aboot yours?:)
Top 4 pins are RX, POWER, GROUND, TX in that order.
Female pins @ bottom are for LCD.
Debug LED on Left.
Beginning of my debug station.
Next, adding RF Receiver and Transmitter.
And the chip of course!
Just pictures of me sexy case!
Top of the case!
Just using the Arduino board for power/uploading sketches atm
Before soldering female headers (on left)
The two capacitors belong to the Crystal.
The resistor is the pull-up, for reset.
Top left is the Reset button.
... I'm still learning.
I had to remove the copper tracks to make sure the lcd would fit right.
Now I'm stuck with this!
I need to secure the female header, almost time for some hot-glue!
It's ugly.. but it works, for now.
TX, GROUND, POWER, RX
90 degree female pins on other side, for "easy" uploads!
Well, who doesn't love http://letsmakerobots.com ?!
Just a simple example of the LCD working.
(Yes, on my "Ghetto-duino")
(I wish the bottom looked this good!)