Some of the parts you will need, PVC Glue, connectors, 1" ballcock valve, 1" Reinforced Bilge hose, 1" Stainless hose clamps, dual #12- #14 marine wire. 1" graded intake manifold.
1" underside intake manifold
1" Reinforced Bilge Hose 35' for two pumps on a 19' Goat
Make your Vent holes absolutely Last 1" hole saw and grind out the addiitonal space you will need for the threaded vent piece
Mark your intake hole carefully, take your time.
Remember, pumps are NOT waterproof, so mount them places you can get to them and lay them out so the hoses do not crimp.
All intake hoses are connected to the lowest point on the sacs. The vent is connected to the highest point. You may chose to use a check valve, but it is optional. 2 W743 1" Quick connect to go on the sac. 1 W746 - 1" Flow-Rite Elbow Quick Connect
1" Vent coupling, FlyHgh has them in stock, don't look for them get them from them, they are a good quality. Use RTV 5200, Marine Glue for all Hull Couplings (Walmart has it for 7 bucks !!. Don't use clear silicon glue.
Try and match the size of your area with the size of the sac. Remember, the sac will not overfill. It will conform to the size of the area within reason.
Clean sharp areas from the hull where the sac will be to keep from puncturing the sac. It will not hurt to put some carpet down. Use 777 Spray glue to tack the carpet down. FYI, you can get cheap Bar-B-Que carpet at Walmart for like $2 bucks.
Very nice Ballast rocker switches that come with the Jasco reversable pumps! You will not find a better switch, trust me.
With a couple of screwdrivers, you can carefully pull the switch out the front so you can use the bezel as a template. Be careful not to strip the bezel or pull too hard and break the switch. There are winged ribbs on each end. Look at the other photos for details on how it looks.
This is what the ribbs of the switch looks.
Cleaned hull with Walmart Bar-B-Que carpet glued on to protect the sac.
Make sure you glue and clamp all the fittings you can. You cannot glue the hose to the Copper single-barbed pumps.
Top of sac using a straight 1" W741 ?Flow-Right Straight Quick Connect, to be used with W743 (one for top, one for bottom)
