I placed some grammets in the spar tunnel for wiring. Hopefully I measured so that the spar clears!
I plan to route the comm and xpndr antenna cables up high away from everything else, so I placed some grommets.
Wires are beginning to get cluttered. I used blue masking tale and marked alll the wires with a sharpie.
Routing of the static line to the back of the plane.
Static line parallels the rudder cable.
Top down of static line running around landing gear and under hydraulic brake line.
I terminate the static line in the rear of the plane as several other builders have suggested and tested. I will also test, verify and modify if necessary.
The Trio wing leveler connects via a Molex, and uses a 4 wire shielded cable tot he MGL Enigma.
I couldn't add labels after being installed, so I wrapped some tape and marked with a sharpie.
I purchased several of these 3 position switches from an antique supplier, and wanted to verify operation. Down is OFF
Middle is ON (taxi)
Up is ON High (Landing & Taxi)
My first pass on the cooling fins was with a grinder. I really think the belt sander worked the best.
Just getting started!
